Yamaha Zuma '89-'01
Dr Pulley slider kit 15x12
$ 30.99
These differ from rollers, as they don't roll in the variator, they slide. These sliding rollers perform better than standard round weights by allowing the variator to open farther for...
Domino grips "Coppia Mannipole"
$ 14.99
Domino grip set in a pair. Super comfortable with a OEM feel. These are a Piaggio style, and Will fit any 7/8th bars. Overall length: 118mmThrottle type: 22mm throttle twist...
Dellorto rebuild kit PHVA PHBN
Sold Out
Rebuild kit for you Dellorto kit. Includes all seals, float, clip and needle.
DELLORTO PHVA PHBN 12-17.5 FLOAT KIT
$ 19.99
Replacement float, needle and pin for your 12-17.5 Dellorto PHVA PHBN Please verify you have a carb matching the description before ordering.
DELLORTO PHBG rebuild kit
$ 29.99
Rebuild kit for your Dellorto PHBG. Full kit, including float, needle, air idle screw, idle screw and all new gaskets/needle c clip and spring. SUPER handy to have on hand...
Dellorto PHBG needle kit
Sold Out
New! Dellorto tuning kit for the needle on PHBG carbs, this is a must have if you have a PHBG, typically we and up between w7-w9 Includes W3 / W4...
Dellorto Main Jet Kit
$ 25.99 $ 26.99
Here's the one time solution for your dellorto. Save yourself the hassel and expense, and just buy the full kit. Its far less money in the long run, and its...
Dellorto Carb 17.5mm MANUAL CHOKE
Sold Out
This is an extremely popular carb for Minarelli setups. It's ideal for 70cc kits. Trusted name, and known performance. Manufactured by Italian carburetor specialist Dell'Orto. Rubber mount, for cable choke...
Dellorto Cable Choke Conversion Kit
$ 29.99
Need to convert your two screw Dellorto to a choke cable? This is the kit you'll need. Remember, you still need to buy the cable, and this is ONLY intended...
Delloro PHBG pilot jet kit
Sold Out
Save your money with this set of 10 pilot jets for Dellorto PHBG - PHBD carburetors. You receive a set of 10 with 5mm thread in the following sizes ...
Dellorto Manual Choke Cable Kit PHBG
$ 18.99
Add a cable of your own, or from this site, to install choke on your Dellorto! Dellorto Manual Choke Kit with cable duct PHBG
CUSTOM BUILD INVOICE
$ 30.99
Hey folks, we've changed things up a bit! If you’re looking for an engine build package, we're happy to spend the time building you the invoice - but it does...
crank seal installer tool
Sold Out
Plastic crank seal installer tool made right here in Portland. Zero risk of marring up your case/seal, and crankshaft! These are meant to be used to PUSH the seal in,...
Crank Installation Tools
Sold Out
Ok, so most of know, that a press/mallet/hammer is the incorrect way to install a crank. And its also the incorrect way to remove a crank. Cranks are not designed...
10mm Banjo washers
$ 7.99
Replacement copper or aluminum washers for your master cylinder, or caliper. Fits all standard M10 fittings. This is a (2) pack.
Cooling Fan Scoop Minarelli
$ 19.99
Need some extra cooling on your performance build? too inexpensive not to buy this little guy. This scoop may require trimming depending on the application. If you built your bike,...
Clutch holding tool
Sold Out
Universal tool for holding clutch or variator. super easy to use, and a great tool to have in your toolbox.
Clutch bell nut for minarelli
$ 9.99
Here's a fresh clutch bell nut for your Minarelli vertical, or horizontal. Its good to replace these guys after removing and installing the nut a few times. Old nuts, and...
Canyon dancer strap tie down rings
Sold Out
The Strap Ring is made in the USA of stainless steel. It allows tie-downs almost anywhere there is an 8mm or smaller bolt (smaller bolts obviously are not as strong). ...
cable pinch screw
$ 4.99
These guys are necessary if you're doing any custom cable work. These are used on the twist throttle end. If you have a cable that's too long, or needs a...
Cable choke adapter
$ 19.99
If your trying to install a Stage6, or other cable choke on your OKO, Keihin, or PWK/Polini D slide Carb, you need this guy to seal the deal. This is...
Fuel or Oil Line Clamp
$ 23.99
Hose clamp tool is awesome for keeping the fuel and oil mess to a minimum. Clamp this guy to your carb fuel line, oil injection line, or whatever you want,...
Center stand for 89-01 zuma
$ 66.99
Replacement center stand for your 89-01 Zuma! Replace that crusty old, bent, rusted out stand with a fresh one. Includes new hardware as well!
Buy Paul an Energy drink
$ 2.99
Paul is a hardworking individual who enjoys raising his heart rate with caffeine, and is also responsible for working on shipping all products along with ordering new ones. Show your appreciation by...